Drywall isn't structural, so there is no way it would support much weight, let alone the momentary impact from someone grabbing the bar during a fall. Never rely on anything but solid 2x wood blocking, concrete, concrete block, or some other substantial material as a mounting platform for a grab bar. Drywall can be covering the substantial material, but fasteners have to penetrate through the drywall and deep into the mounting block material.
Flat end grab bars are made of stainless steel and are appropriate for outdoor use. All other specialty grab bars, being made of carbon steel, will rust eventually when exposed to outside conditions.
These bases have a mild steel frame that is part of their internal structure. Each steel tube that makes up the frame is set back from an edge of the base by about 1". Cutting through these tubes weakens the structure and may reduce the load capacity of the base, depending on how the base is supported underneath.
While facing toward the stairs or a passageway where you want to install the grab bar, you will need a left Newel Grab Bar to mount to the left newel post or corner, and a right Newel Grab Bar to mount to the right newel post or corner.
The primary differences are size, load capacity, and the metal used.
The seats are smaller in the Economy series compared to the more generously sized Deluxe models. Deluxe seats are made with heavy gauge stainless steel tubing in the legs and frame, whereas aluminum is used in the Economy series. Deluxe seats will support up to 560 lbs. when properly installed, and Economy seats are rated to support 348 lbs. when properly installed. Plastic mounting brackets are used on the Economy seats compared to stainless steel in the Deluxe seats.
All in all, the Deluxe series is stronger, more durable, and more spacious.
It depends. These seats are meant to be mounted to a wall, so that is a must, and the feet need to rest on a flat surface so that they will not slip, which will put sideward pressure on the leg joints and hinges, especially when someone is sitting on the seat. Many tubs have a rounded bottom surface, which may cause this effect to occur.
Sorry, but there is no way to convert a seat from no-back to one with a back.
All Economy seats swing past 90° to lean toward the wall. This is sufficient to keep them in position until a user swings the seat back down. The only reason a seat would fail to stay upright is if the wall is badly out of plumb, leaning toward the shower in a way that prevents the seat from completing the over-travel path.
Yes, new pads are available. Please see the specification sheet for any seat model you have, and there you will find item codes for the correct replacement pads.
All covers are 1/2" deep.
It's a snug fit. There are round rubber bumpers that you insert into pre-bored holes in the side walls of the cover. Pressing the cover into the adaptor squeezes the bumpers just a bit, making for a snug fit. The cover will come out only if you want it to.
Fitting grates across manufacturers is tricky because there is no common standard. Out grates are made to metric dimensions that equate to 3/16" thick x 4-7/16" wide x 4-7/16" long.
©2025 ARC Inc. All Rights Reserved | Website by Super Digital