Description
TriForm shower bases feature a fully integrated drain gulley molded directly into a structural, pre-pitched base that can support a maximum capacity of 560lbs and can be beautifully finished with ceramic tile or natural stone.
Precisely sloped to ensure quick, accurate drainage, TriForm can be installed directly onto joists to create a curbless shower flush with the bathroom floor, making them wheelchair and disability friendly, as well as easier to clean and safer to use for the whole family, for years to come.
Product Specification:
- 560lbs max. capacity when installed on 16″ o.c. joist systems
- Approx weight: 43lbs
- Install on wooden joists (no need to notch, lower or alter joists), sub-floor, or concrete
- Cannot be cut or trimmed due to the internal structure of the base
- Extend length of pitch to comply with ADA regulations using Pitch Extension panels
- 4 pre-sloped gradient planes direct water flow towards drain
- 2% per foot or greater gradient
- Integrated drain gulley with up to 3 locations for you to connect to the drain line
- During installation, ensure the drain gulley hangs between joists for clear access to drain line
- 7/8″ thick around perimeter
- 1¾” wide leveling rim around perimeter with pre-bored, countersunk pilot holes
- Finish with tile or stone (between ¼”-1″ thick)
- For tile that is 2″ x 2″ or smaller, conform to the pitched contours of the base; for tile larger than 2″ x 2″, make valley cuts so the tile lays properly on all pre-pitched surfaces
- Covered by AKW limited lifetime warranty
- You will need an AKW Waterproofing Kit and Tuff Form Linear Drain Cover
- For more details, see Specification Sheet
- Review installation instructions before beginning your project
